Description
Staerk Silicone Sealant N60 is high quality one component, neutral room temperature curing sealant. This sealant has an anti-fungus agent and its perfect for high humidity areas. It effectively seals most building materials: glass, coated aluminum, wood, glazed ceramic tiles, fiberglass, vitreous enamel and most laminated surfaces. Ideal for ceramic tile grouting and sealing around bathtubs, shower stalls, wall fixtures, rimless sinks, kitchen and bathroom fixtures.
Ceramic tile grouting
- Elastic waterproof seal of vinyl, tiles and laminated flooring to walls
Granite, Marble, Laminated benchtops
- Creating waterproof seal between sinks and benchtops
- Joints between benchtops and splashbacks or tiles
- Sealing between cabinetry and walls or floors
Bathroom and Laundry areas
- Sealing and waterproofing bathtubs
- Sealing and waterproofing toilet suites and bidets
- Waterproof seal for the basins and vanities
Plumbing fixtures
- Waterproofing plumbing fittings for bathroom, kitchen & laundry
- Sealing traps, wastes, pvc pipes, incinerators, filters, etc
Door & Windows Glazing
- Sealing and waterproofing glass to windows and door frames
- Waterproofing and bonding of glass shower enclosures to tiles
Health and Safety
- Non Toxicity when cured
- If medical advise is needed have product container and label at hand
- Read label before use
- Gloves and goggles must be worn during application
- If skin contact occurs remove the sealant with cloth and wash skin thoroughly with water and detergent for a minimum of 15mins
- Avoid eye contact before curing. If this occurs rinse opened eye for several minutes under running water, then consult a doctor.
- Ensure proper ventilation at workplace or curing area.
- Keep away from children.
Preparation
- The base material need to be free of dust and grease or loose material. If needed clean up with a turpentine wet rag or cloth and let it dry. Complete adhesion test before use and make sure good compatibility and viscosity of the sealant with base materials.
Application
- Cut off the top of the cartridge, position the threaded adaptor to the cartridge. Cut the threaded adaptor at an angle corresponding to the joint width. Place the cartridge into the gun and inject the joint with the sealant. Apply sufficient pressure to the sealant to ensure good penetration and adhesion to the joint sides. The applied sealant should be smoothed immediately with a wet spatula or jointer to clean off excess sealant. Staerk Silicone Sealant N60 is not suitable for bonding polyethylene, polypropylene, Teflon, silicon or polystyrene based materials.
Cleaning
- Clean while uncured with a turpentine cloth. After hardening remove the silicone sealant mechanically or with a silicone remover.
